VT

Priority Tiny (VT or VTL)

VT-TINY or VTL-Tiny DIL Chip

Available in DIL or SMD packages
Printable version available here


Usable for:

• Stop signs (a vehicle stops itself)
  
• Priority control (a vehicle stops other vehicles)
  
• Construction zones (a vehicle stops itself)
  
• Narrow sections (a vehicle stops oncoming traffic)
  
• Parking/Bus stops (a vehicle stops other vehicles)
  
• Priority control for left-turners VTL (a vehicle stops vehicles that have their left turn signal activated)

The Priority Tiny can be used with the DC-Car system to control traffic.

When a vehicle passes over a sensor (reed switch, HG1 Hall sensor, IR sensor, or phototransistor), an IR stop signal is generated for an adjustable duration. Consequently, this traffic control module can also be referred to as a Construction Zone Tiny, Narrow Section Tiny, or Stop Tiny.

The timer resets and begins anew each time the sensor is triggered. Maximum 60 seconds (600 sec)
Thus, heavy traffic can permanently block the side street.

Only vehicles with their left turn signal activated will react to the stop signal from the VTL.

Parts List for 5 Volts 5-Volt operation only Servo-Tiny PCB IC2 = VT-Tiny (DIL) C1 + C5 = Tantalum capacitor 4.7µF/16 Volts C3 + C4 = Tantalum capacitor 1µF/16 Volts R1 = Series resistor for IR LED: 150 – 680 Ohms R2 = Potentiometer: 10K – 50K R4 = Resistor: 270 Ohms R6 = Resistor: 100 Ohms (soldered vertically) R7 = Resistor: 10K	Accessories: 8-pin screw terminal block     (2.54mm pitch) 4-pin header strips     (for 5V connection) IR LED Reed switch / Pushbutton or Hall sensor HG1 Plug-in power supply unit   5V DC or 12V DC PCB (DC-Car-Servo-Tiny)     or perfboard	Bill of Materials for 12V DC or 16V AC Additional components. D1 = 1N4001 Diode IC1 = 78S05 Voltage Regulator C2 = Electrolytic capacitor 470µF / 35 Volts

DC-Car Board for VT and VTL (Servo-TINY Board)

Illustration for 12V DC or 16V AC
The 5V connection can be used for additional VT units or other modules

VT_Board 2015

VT_Board_2

Pre-assembled Modules VTLF and
VTLIRF (up to 16V AC; Reed Switch and FTR)

These pre-assembled modules do not correspond to the construction guide!

Version with Reed switch or Hall sensor only

IR also for phototransistors Note: FTR - +

---

Delivery, Service, and Troubleshooting

Service@modellautobahnen.de   S.Dankwardt 02103-9070350 dc-car-shop.de        Further info: WIKI-DE.DCCar.info     dc-car.nl              Further info: WIKI-NL.DCCar.info Sources of Supply: Dealers, Shops, Pickup Points   Service and Help

---

---